Frequency Stability, Overall ±4.6ppm [-40°C to +85°C]
Operating Temperature Range to -40°C to +105°C
Voltage Control Option for Frequency Tuning [VCTCXO]
Enable Function Option Available
Tape and Reel Packaging, EIA-418
Part Dimensions:
5.0 × 3.2 × 2.0mm
Standard Frequencies
* See Page 7 for common frequencies.
Check with factory for availability of frequencies not listed.
Applications
5G, 4G, LTE
Femtocells, RRU, BBU
Military Radio [Manpack]
Inflight Entertainment
Autonomous Technologies
Synchronous Ethernet
IP Networking
Medical Imaging
Stratum 3
IEEE 1588 Timing
Wireless Communication
Test and Measurement
Description
CTS Model 536 is a high performance Temperature Compensated Crystal Oscillator [TCXO] suitable for
applications requiring tight stability, Stratum 3 performance and more. Employing IC technology with HCMOS
output and analog temperature compensation engine; coupled with a fundamental quartz crystal M536 has
excellent stability and low jitter/phase noise performance.
Ordering Information
Model
536
Output
Enable
Supply
Voltage
L
Frequency Code
[MHz]
Frequency
Stability
X2
2
XXX
Temperature
Range
I
Frequency Tuning
T
Packaging
5
Code Function
Blank No Enable
E Enable, Pin 3
Code
Frequency
Product Frequency Code
1
Temp. Range
Code
-10°C to +70°C
C
-40°C to +85°C
I
G
-40°C to +105°C
3
Code
01
X2
05
Stability
±0.10ppm
±0.28ppm
±0.50ppm
Frequency Deviation
Code
T
TCXO
[No Voltage Control]
A ±5ppm - ±10ppm [
VCTCXO
]
Packing
Code
5 500 pcs./reel
Code
L
Voltage
+3.3Vdc
Notes:
1] Refer to document 016-1454-0, Frequency Code Tables. 3-digits for frequencies <100MHz, 4-digits for frequencies 100MHz or greater.
2] Frequency vs. Temperature only.
3] Available with stability code X2 and 05 only.
Not all performance combinations and frequencies may be available.
Contact your local CTS Representative or CTS Customer Service for availability.
This product is specified for use only in standard commercial applications. Supplier disclaims all express and implied warranties and liability in connection with any use of this
product in any non-commercial applications or in any application that may expose the product to conditions that are outside of the tolerances provided in its specification.
The following is the information I got from the Xilinx official forumThe definitions of the two refer to the following descriptions:
IBUFDS:
This design element is an input buffer that supports low-vo...
We learned about voltage in junior high school physics. Voltage is also called potential difference, which is the difference between any two potentials. It is generally believed that the potential at ...
[align=left]Based on the N76E003 market, Nuvoton Technology launched the 003 series platform, which is a direct replacement for N76E003AT20/N76E003AQ20. For software and hardware migration, please ref...
Um, well, for me who doesn't know much about hardware, this question is actually very simple.For example, if you want to hack a switch on a device.
The simplest idea is, of course, to just get a relay...
Shenzhen Topway has newly launched an intelligent module that adds LUA functions, which can easily embed logic control programs into it. The following video is an experience of playing a Tetris game u...
13 1.8-inch digital tubes and 5 2.3-inch digital tubes, most suitable for electronic clocks. The 1.8-inch circuit board has a transistor driver. All digital tubes are red and green. 40 yuan free shipp...
Spring is back, and everything is revived. On February 29, the Yongren County 300MW/600MWh independent energy storage demonstration project was officially launched. Zhang Wenwang, deputy secretary of ...[Details]
SNE Research, a Korean new energy vehicle battery market research organization, held the two-day NGBS 2022 (Next Generation Battery Seminar) at COEX in Seoul from April 13 to 14. At the meeting, J...[Details]
Audiophiles who pay attention to music details know that the preamplifier plays a connecting role in the audio circuit, and it has an impact on impedance matching, dynamic development, and the perf...[Details]
The application range of flowmeter is very wide, and special attention should be paid to the environment, operation, installation, etc. during use. Because these many factors will affect the measureme...[Details]
0 Introduction
Z scanning is a method used in optical nonlinear measurement. This method can be used to measure the size, positive and negative, and nonlinear absorption coefficient of the non...[Details]
In C51 , how to access a certain address unit in DATA space, PDATA space, XDATA space, CODE space?
A: Macros that access memory using pointers
When using it, you need to use the preprocessing c...[Details]
In its latest preliminary monthly generator inventory report, released on January 9, the EIA said that planned and operating utility-scale battery capacity in the United States will...[Details]
For some time now,
many engineers and developers have been discussing the future of embedded processor architectures.
While there are clear leaders in the embedded chip architect...[Details]
At the 9th Guangzhou Auto Show, the TID powertrain installed on the BYD G6 model once again aroused our interest. This power combination seems to be completely comparable to Volkswagen's TSI+DSG, a...[Details]
C51 memory types include bit sbit data xdata bdata pdata sfr code, etc., which may not be comprehensive and may be omitted. The corresponding physical memory is:
bit, that is, bit data: data memory...[Details]
According to foreign media reports, although solar panels are very effective, one of their main drawbacks is that they only generate energy during the day, so excess energy needs to be stored for use...[Details]
The development trend of chips is that the storage capacity is getting larger and the price is getting cheaper. So we should use C to write microcontroller programs, and assembly is not recommended. ...[Details]
The scale of SoC chips is generally much larger than that of ordinary ASICs. At the same time, the design difficulties brought by deep submicron technology have greatly increased the complexity of ...[Details]
/***************************************
Experiment on reading and writing AVR microcontroller EEPROM.
First write 254 to the microcontroller EEPROM, then read 254
and display it on the digital ...[Details]
The push-pull converter circuit shown in Figure 12 is actually composed of two single-ended forward converter circuits. Therefore, when the switching transistor is turned off, the voltage on each swi...[Details]