Tianer Technology was established in 1988 and has the R&D capabilities and manufacturing technology for chip resistors and arrays. In the face of today's diverse customer needs, we continue to invest in the development of high-quality products and new manufacturing technologies, and provide customers with a one-time purchase service for multiple components to fully meet customer needs and improve customer satisfaction with our products. In terms of quality management, our company has passed ISO-9001, ISO-TS16949, TTQS certification and complies with the AEC-Q200 automotive electronics self-testing standard. We continuously improve the quality of our products and services through the analysis and improvement of product yield rate indicators, customer satisfaction surveys and other reports, in order to enhance customer trust in our company and establish a good partnership with our customers.
When multiple MOS tubes are connected in parallel, do they have to be symmetrical? I saw this on Baidu. How do you calculate the current-sharing resistor?...
The following program uses the up-counting mode. When the value increases to TA0CCR0, a TA0CCR0 interrupt will be generated. Then the counter will be automatically cleared and count again.
【Note】: Thi...
Condition: Only the MOS tube is burned out and the DS is short-circuited (all three MOS tubes are burned out. It has been working for about a month. The time varies according to the load size.) Descri...
Dear teachers, if anyone has experience in developing analog chips such as CS1256 , CSU18M91 , HT45F75 , SD6505, and has the intention of cooperation, please add jdygf2 to communicate, thank you!...
Why is a large capacitor connected in parallel with a small capacitor?
At high frequencies of the same frequency, the impedance of a large capacitor is smaller than that of a small capacitor, and it h...
PCB Design
京公网安备 11010802033920号
EEWORLD
