After a power outage, it is prohibited to reconnect the circuit when a call comes in b
Source: InternetPublisher:风向西瓜 Keywords: relay noise switch Updated: 2020/07/04
It is forbidden to reconnect the circuit
when a call comes after a power outage. This can avoid
accidents caused by forgetting to turn off the electrical appliances and power grid in use when the power comes back again . It can be easily implemented using relays or contactors, as shown in Figure 13-77 (a), but the relay coil
consumes power, and when the load power is large, contactor control is required, which is bulky and noisy . If
a bidirectional thyristor is used as a contactless switch , the problem can be solved.
- One-digit display
- Resistor value selection circuit
- Corridor automatic light-off device
- One of the bead-type emergency light circuits
- Chandelier brightness controller circuit using thyristor
- Gas and smoke alarm circuits with intermittent alarms
- Economical and practical delay light circuit
- Fluorescent dimming circuit (1)
- Small current anti-theft alarm circuit
- Reverse polarity drive circuit
- Diode Balanced Mixer Circuit
- Voice recording and playback circuit
- Music box voice circuit
- Water full alarm circuit
- Instantaneous water heater automatic constant temperature experimental circuit diagram
- Contactless switch conversion circuit a
- Two lamps and one switch incandescent lamp parallel lighting circuit
- How multi-resonators workb
- Pulse shaping circuit using inverters
- Application circuit of XR1071