Microcontroller controlled flash circuit
Source: InternetPublisher:同住地球村 Keywords: Power supply other power circuits Updated: 2020/07/25
This circuit can light up two lights in a cycle. This circuit is an astable multivibrator composed of a transistor (NPN9014, DC amplification factor should be >200), a red light-emitting diode and R and C components, and is powered by a 6V DC power supply. Execute the microcontroller programming process as shown in the figure, and you can see the two tubes flashing alternately.
Latest Power Circuits Circuits
- Analysis of the working principle of switching regulator
- Introduction and principle analysis of switching regulated power supply
- Single-power supply circuit for ISO122P/ISO124
- Driving circuit that controls LED brightness using PWM signal
- LNK304 non-isolated LED light string driver circuit
- A simple positive and negative power supply circuit
- Adjustable regulated power supply with current limiting protection
- Power supply circuit that can reduce LM317 ripple
- CNC regulated power supply production
- Adjustable voltage regulated power supply circuit
Popular Circuits
- Determining the prerequisites for successful circuit board design
- About star-delta step-down start plc ladder diagram circuit diagram
- Photosensitive automatic dimming desk lamp circuit and principle
- Humidity detection circuit schematic diagram
- Two-channel low-power amplifier circuit
- Heart rate detection circuit
- How to use "virtual short" and "virtual break" to analyze op amp circuits
- Unity gain four input audio mixer
- Dual tone generator for audio
- Simple mode logarithmic amplifier circuit of LOG100
京公网安备 11010802033920号