Use hexadecimal data to select a programmable amplifier with a gain of 0 to 15 times
Source: InternetPublisher:小胖友 Keywords: Programmable amplifier BSP resistor value Updated: 2020/11/23
The working principle is very simple. The amplification factor of the inverting amplifier
depends on the ratio of the resistance values
. So the feedback resistor R is set to 80kQ,
which is marked intuitively. Use other resistors. The value doesn't matter. To make the amplification
factor 1, take U=80ki:, the amplification factor is 2, R*=40kQ, the amplification
factor is 3, the resistor value should be 26.666kQ, this resistor is virtual - in fact ,
after the data bits (A, port) amplified by l times and amplified by 2 times are connected at the same time, the parallel
resistance value is 80 x 40+(12 0)=26. 666.
Like this, put the /', 1/^ weighted resistors are connected in parallel in sequence , and
a total resistance of 0-15 times can be obtained.
In order to control with logic levels, a 4-contact C-MOSlk
pseudo switch can be used. But pay attention to the on-state resistance existence. As for the measures to reduce the error,
some use the same switch and the feedback resistor R, connected in series to become the on state.
However, since up to 4A1 can be turned on, a balance cannot be achieved.
The resistance value should be larger than the transition resistor. To reduce the error (×8 data bits D, its resistance is
.lc}kQ,. If t... is 50QI,, the error is 0.5").
- Digital electronic thermometer using semiconductor diode as temperature sensor
- Simple infrared detector
- Using a Remote Control to Make a Crystal Oscillator Frequency Tester
- Inductive Pointer Watch Battery Tester
- 5 tone detector circuit diagram
- Application of TDA1514
- AC ammeter circuit
- Digitally controlled operational amplifier gain circuit
- 3W portable megaphone circuit
- Low power audio amplifier MC34119-03
- strain sensor
- Electric massager circuit
- Agricultural spraying and insecticide control circuit
- Farmland drainage automatic control circuit
- Mixer built with analog multipliers
- Junction field effect transistor mixer circuit
- collector amplitude modulation circuit
- Common emitter-common base wideband amplifier circuit composed of F733 integrated amplifier
- Voltage controlled power supply second-order high-pass filter circuit
- Power phase sequence display circuit