600Ω balanced driver preamplifier with output greater than 20dBm
Source: InternetPublisher:newrudeman Keywords: Preamplifier BSP Updated: 2021/08/17
As long as LtPC1238 is regarded as a power OP amplifier, the working principle of this circuit
is easy to understand. The voltage amplification factor is determined by the resistors j and R', A≈48
times (33.6dB)o between the output terminal and the ground, Ca is the impedance correction component ,
which increases the reactance and stabilizes the circuit operation.
The boost ratio of the output transformer is given by the formula. "=,/Z:/Zi calculation outlet In
the example, n=2, so when the load is 6000,
an amplitude above 40vl.r can be obtained.
- Lightweight and practical multi-core cable detection circuit
- Balcony intelligent invisible anti-theft net
- Homemade refrigerator monitor
- Analysis of valid and fault conditions of differential signals
- A low-cost inductance meter consisting of a single IC
- How to create a simple oscilloscope using the Basys3 board
- PHGS-4 computer multi-channel industrial acidity meter circuit 01
- Digitally controlled operational amplifier gain circuit
- AC equivalent amplifier circuit
- Differential amplifier circuit
- Motor forward and reverse control wiring diagram (2)
- Chicken supplementary light to increase egg production rate circuit
- Soil water shortage prompt circuit
- Farmland irrigation automatic control circuit b
- AC voltmeter
- ring amplitude modulation circuit
- Parallel crystal oscillator
- OTL low frequency power amplifier circuit
- Wireless microphone circuit
- Digital stopwatch display circuit