Active electronic crossover power amplifier system
Source: InternetPublisher:风向双子座 Keywords: amplifier Updated: 2021/08/10
The specific circuit of this system is shown in Figure 9. The external input signal from the front stage is first sent to the buffer composed of IC A.
The signal output by 1CA is divided into two channels and sent to IC respectively]. The second-order BUTTER WORTH high- and low-pass filters composed of 1C2 and IC
3, Ic4
have their slope set at 24d B/oct and the frequency division point set at 4kHz. The divided signal is then sent to the filter
composed of 1CB Icc The buffer performs impedance transformation to match the impedance of the subsequent power amplifier .
- Simple and easy to make zero degree detector
- Simple and practical EPROM detection circuit
- Balcony intelligent invisible anti-theft net
- New function added to MF-47D multimeter - infrared remote control detection
- Temperature-frequency conversion circuit composed of CD4046
- An electronic load meter using LM324 operational amplifier as the main control device
- Directly coupled push-pull power amplifier circuit
- High-speed gain programmable amplifier circuit
- Temperature voltage conversion circuit
- Numerical control following or inverting circuit
- AC negative feedback analysis of OCL power amplifier
- Use LM3876T to connect to BTL power amplifier
- 60W high-fidelity power amplifier
- Active electronic crossover power amplifier system
- Production of high-quality active two-way constant current power amplifier 02
- Imitation AURA-VA50 amplifier
- Upper and lower symmetrical negative feedback mode field effect transistor power amplifier 01
- ALA amplifier and motor
- Class S power amplifier 02
- HI-FI amplifier 01 made by STK4040x1
京公网安备 11010802033920号