A HI-FI active integrated speaker 01
Source: InternetPublisher:风向西瓜 Keywords: Speakers HI-FI MDASH Updated: 2021/03/25
The circuit principle of the preamplifier circuit, power amplifier and power supply part is shown in Figure 9-71. Each channel of the convex preamplifier stage is composed of the king of
two-stage operational amplifiers NE5532. The first stage is a non-inverting amplifier, which has a very high The input impedance and extremely low output impedance
are used to isolate the subsequent stage and avoid the influence of the load. 4 The output of the first stage
is sent to the second stage through a three-frequency (100Hz, 100Hz, 1000Hz) balanced network. RP1, RP2.RP3, etc. form an inverting amplifier. The functions of RPl.RP2 and RP3
are shown in the amplitude-frequency characteristic curve in Figure 9-72. Due to the use of low-noise, high-speed NE5532 in this part of the circuit, the signal-to-noise ratio,
dynamic range, transient response and control effect of this unit have reached a very high level.
- DIY Metal Detector
- Analysis of valid and fault conditions of differential signals
- TC02 temperature measurement circuit
- Circuit Fault Tracker
- Using a Remote Control to Make a Crystal Oscillator Frequency Tester
- Electric vehicle luminous voltmeter with undervoltage alarm
- Use LM3915 to make a practical audio power meter
- DC power meter
- Typical two-stage low-pass filter circuit
- High Performance Digitally Controlled Amplifier-Gain Divider
- stapler main circuit
- Temperature control system block diagram
- Infrared anti-theft alarm circuit one a
- Ten-band frequency equalizer
- A HI-FI active integrated speaker 02
- Homemade high-fidelity fever HI-FI amplifier 05
- A HI-FI tube power amplifier 02
- Open loop speed control
- JS88 holiday lights catch yo integrated circuit
- Field output circuit: TDA3654 circuit diagram
京公网安备 11010802033920号