Problems when burning after CCS3.3 is installed on win7 32-bit system

狸子小昭

Problems when burning after CCS3.3 is installed on win7 32-bit system [Copy link]

Error connecting to target: Error 0x80000240 / 2092 Fatal error during initialization, Device Driver: Loss of emulation connection detected on target CPU. Recommend resetting the simulator. This will disconnect each. target from the simulator. Targets should be power cycled. or hard reset after emureset and reconnecting to each target. I/O port = 240 Name: F28335 XDS510 Emulator Board CPU Name: cpu_1 Abort: Closing Code Writing Studio. Retry: Try connecting to target again. Cancel: Remaining disconnected from target Diagnose: Run diagnostic utility.

狸子小昭

Please tell me the solution

狸子小昭

Error connecting to the target: Error 0x80000240/-2092 Fatal Error during: Initialization, OCS, Device driver: Emulation Connection Loss Detected on Target CPU. It is recommended to RESET EMULATOR. This will disconnect each target from the emulator. The targets should then be power cycled or hard reset followed by an emureset and reconnect to each target. I/O Port = 240 Board Name: F28335 XDS510 Emulator Cpu Name: CPU_1 Abort: Close Code Composer Studio. Retry: Try to connect to the target again. Cancel: Remain disconnected from the target Diagnostic: Run diagnostic utility.

数码小叶

Is the project configuration wrong? My 64-bit and 3.3 are all fine. Anyway, I found that the dsp errors are all weird, and each error message does not match the actual solution.

elvike

Never used 3.3

szczyb1314

3.3 is classic but has many problems, please change to a higher version

狸子小昭

After uninstalling the plugin, reinstall it. It should be that the path was not selected correctly when the plugin was installed. It is necessary to install the corresponding four plugins

Lixiaodou_163

I am using CCS3.3 to develop DM6437, window7 64bit seed560plus, and I need the files shown in the figure