STM32F107 Jlink debugging

shrxh

STM32F107 Jlink debugging [Copy link]

When downloading the program to the development board, it shows Erase Done. Programming Done. Verify OK. But it does not show application running. The board does not respond at all and the program cannot be written in. Please give me some advice.

wudayongnb

Did you download it directly using Keil or using SEGGER's jflash?

shrxh

wudayongnb posted on 2017-12-30 20:40 Did you download it directly using Keil or using SEGGER's jflash?

keil

shrxh

shrxh posted on 2017-12-30 20:42 keil

I downloaded keil directly, I followed the video tutorial. There is no problem downloading the program provided in the tutorial to the board, it can display application running, but the one I wrote cannot display

qwerghf

Check the reset run menu of the configuration

shrxh

qwerghf posted on 2017-12-30 21:44 Check the reset run menu of the configuration

Where is the reset run menu? I am a newbie and can't find it

qwerghf

As shown in the figure below

shrxh

qwerghf posted on 2017-12-30 21:55 As shown in the figure below

The problem has been solved, thank you very much

ddllxxrr

Restart the development board.

shrxh

ddllxxrr posted on 2017-12-31 08:15 Just restart the development board

Thank you