Solution to CC2530 Z-STACK Fatal Error[e72]

Jacktang

Solution to CC2530 Z-STACK Fatal Error[e72] [Copy link]

In IAR 8.1, when builder Z-STACK based on CC2530F256 chip, if IAR environment is not set properly, the following error will occur: Fatal Error[e72]: Segment ZIGNV_ADDRESS_SPACE must be defined in a segment definition option (-Z, -b or -P) The solution is as follows: 1. In General options: 2. Select Target, and in Device Under information, select Device: CC2530F256.i51

C:\Program Files\IAR Systems\Embedded Workbench 6.0 for 8051 Evaluation\8051\config\devices\Texas Instruments

2. Linker settings

1) Select the config page and select override under link configuration file default option, click to select the f8w2530.xcl file (default), that is: C:\cc2530_example\link_long_slice_cc2530\20131205\cord\ZStack-CC2530- 2.3.0-1.4.0\Projects\zstack\Tools\CC2530DB\f8w2530.xcl

Roman]output page

In output file, select the option override default, and fill in the modification to :coord.hex file

3. Debug settings

In the Setup page, select Texas Instruments

under Driver