Wiring Problems

chenbingjy

Wiring Problems [Copy link]

I was drawing a PCB. At first I used AD9. I found that when I was routing, normally the wires would follow the mouse. but when I was routing, the wires did not follow the mouse. Nothing happened. Only after I had routed the wires and pressed the right button of the mouse, the wires were displayed. Later, I installed AD10 and the situation was the same. Could you please tell me what's going on? Thank you!

qwqwqw2088

The AD9 distance measurement problem that the OP posted a few days ago, have you solved it? These questions are very strange, they don't seem to be software settings problems, they seem to be cursor problems, etc., there is a problem with the mouse, is it a wireless mouse?

chenbingjy

qwqwqw2088 posted on 2017-12-23 11:39 Have you solved the AD9 distance measurement problem that the OP posted a few days ago? These problems are very strange, they don't seem to be software settings problems, they seem to be cursor problems...

Not solved. It's not a wireless mouse

qwqwqw2088

chenbingjy posted on 2017-12-23 11:41 Not solved. It's not a wireless mouse

TP Look at the settings of this place

chenbingjy

qwqwqw2088 posted on 2017-12-23 12:41 TP Look at the settings of this place

Mine is the same as yours