When burning MCU firmware from Jlink V7.90 to the latest version of J-flash, the MCU flash base address cannot be changed

oyhprince

When burning MCU firmware from Jlink V7.90 to the latest version of J-flash, the MCU flash base address cannot be changed [Copy link]

When the new version of J-flash is burning MCU firmware, the MCU flash base address cannot be changed.
1 Only Jlink after v7.9 has the MCU model I want to use. The jlink software before v7.9 does not have the required MCU. Please don't bother me if you say downgrade the version!
2 It is an outdoor test. I use mobile data to send files and WeChat. There are thousands of Keil project files. The project package is very large. The development engineer often loses the line halfway through sending it via WeChat, or the file is lost (the test will encounter a blind spot of mobile phone signal). It takes half a day to compress and then decompress, so I always send .hex or .bin to burn with jflash. So please don't bother me if you ask why I don't send the project file to compile and burn it with Keil iar. Please don't bother me if you ask me. Please
teach me how to change the flash address to be burned to the target address set by myself in the latest version of Jlink software j-flash v7.9.

Jacktang

like

Why can't I change the MCU flash base address when burning MCU firmware with the new version of J-flash?