In AD, if the circle on the surface of the circuit board is not painted with green paint, should a solid circle or a ring be drawn on the TOPSOLDER layer?

一沙一世

In AD, if the circle on the surface of the circuit board is not painted with green paint, should a solid circle or a ring be drawn on the TOPSOLDER layer? [Copy link]

邀请：@maychang   @jimtien   @caidian   @lugl4313820   参与回复

In AD, if you want to avoid green paint inside the circle on the top surface of the circuit board, should you draw a solid circle or a ring on the TOPSOLDER layer? As shown in the figure below

okhxyyo

Change the aperture to 0

一沙一世

okhxyyo posted on 2022-9-27 15:05 Change the aperture to 0

If the aperture is changed to 0, it will be a non-through-hole pad.

okhxyyo

Yishayishi published on 2022-9-27 15:24 If the aperture is changed to 0, it means that it is not a through-hole pad

You only need to modify that layer. Do not modify other layers.

wangerxian

The purple one is solder mask.
Do you want to make a test point?

jimtien

Draw a solid circle on the solder mask layer