[Shanghai Hangxin ACM32F070 development board evaluation] 2. Build the development environment and turn on the LED

ddllxxrr

[Shanghai Hangxin ACM32F070 development board evaluation] 2. Build the development environment and turn on the LED [Copy link]

 

I don’t think setting up the environment is too difficult, nor is it easy.

Followed the quick start guide exactly.

ACM32F0x0_FP0X系列芯片开发快速上手V0.5.pdf (2.18 MB, downloads: 0)

2022-9-26 20:35 上传

点击文件名下载附件

1. Install the driver

My system is WIN7, and I just need to install the driver. When my board is plugged in,

I followed the quick start guide, found the directory where the driver was located from the disk installation, and then installed it successfully.

2. Algorithm Installation

This is because when I installed PACK, PACK was installed to the D drive instead of the usual MDK. I also followed the quick start to test the FLM file.

In the FLASH directory where MDK is located, you can find the algorithm.

Finally, I found the example code that was just updated in the forum today, compiled and ran the GPIO one, and the long-lost LED flashing came back.

I found that there was a serial port driver part, so I opened the serial port assistant, and the content was as follows:

lugl4313820

My system is WIN7, and I just need to install the driver. When I plug in my board, it looks like this.

The moderator is still using Windows 7. Is he nostalgic?

ddllxxrr

lugl4313820 posted on 2022-9-26 22:53 My system is WIN7, and I just need to install the driver. My board is plugged in as follows. The moderator is still using win7, is he nostalgic?

Shenma nostalgia is no extra money