K210 face recognition environment construction process

筱笙。。

K210 face recognition environment construction process [Copy link]

 

Now that the k210 board has arrived, we will of course try the target detection feature of k210~

First, we need to download MaixpyIDE from the official website of spieed. If you want to program, you always need to sharpen the tool. Since Sipeed Maix Bit does not have a C environment, I use mcriopyhton to program.

Building the IDE is only the first step. You also need a firmware that can run mcriopyhton. Find the latest firmware support package in the download site of the sipeed official website (preferably the latest firmware package, because I found that the previous firmware package could not read the model, which made me suffer for a long time). After finding the download site, click the first one directly, and then you will find that there are many firmwares. Which one should I choose? It is not difficult to read if you know a little English. The minimum means lightweight, and the one with kmodel means that the model can be put in. Of course, I also need to support IDE, so I choose maixpy_v0.6.2_83_gf0280db50_openmv_kmodel_v4_with_ide_support.

After downloading, the next step is to burn the firmware. We need to prepare a software kflash_gui, which is specially used to burn the firmware. The sipeed official website provides a GitHub URL, which not only contains the software, but also the routines everyone needs. In the routines, you can find the trained face model. As shown in the figure below, just follow this configuration, connect the board and you can burn it.

Finally, now you can click on the ide to open it. This is the ide interface. Click the connection board in the lower left corner, and you can run the program happily.

The result is as follows

I will continue to improve my work in the future. Come on, come on, come on!!!

lugl4313820

It's pretty quick to get started, congratulations! Sometimes I run out of memory, I wonder if you haven't encountered this before?

筱笙。。

lugl4313820 posted on 2022-7-9 21:22 It’s pretty quick to get started, congratulations! Sometimes I run into insufficient memory, I wonder if you haven’t encountered this before?

Did you give the wrong address when you burned the firmware?

wangerxian

The IDE can directly see the camera data. This is the first time I have seen such an IDE.