When TMS320F28377D runs CLA, it shows that Cla1Task2 does not contain frame information

烟落无痕

When TMS320F28377D runs CLA, it shows that Cla1Task2 does not contain frame information [Copy link]

Dear experts:

When I was debugging the CLA program of 28377D, I encountered a problem that I have not been able to solve. I hope the experts can give me some advice. Thank you very much!

My CLA is triggered by software. The settings of CLA refer directly to the official routines of TI. The relevant structures have been precompiled into the corresponding RAM according to the permissions of CPU and CLA. There are two ClaTasks in CLA. Now there is no problem when executing the first one, and it can be executed smoothly. However, when executing the second Task, it will stop at the first line of entering the program, and Debug will display "Cla1Task2 does not contain frame information". The relevant screenshots are shown below:

If anyone has encountered this problem before, please give me some ideas for checking it, thank you!

Jacktang

To follow the debugging steps

Are you using routines or your own programs? Are you using RTOS?

RTSC is a C-based programming model for developing, creating or implementing real-time software components for embedded platforms.

XDCtools provides the underlying core tools required by TI-RTOS and its components (including SYS/BIOS). In order to use SYS/BIOS, both XDCtools and SYS/BIOS must be installed.

烟落无痕

Jacktang posted on 2021-9-20 21:46 Do you want to use the routines or your own programs according to the debugging steps? Do you use RTOS? RTSC is a C-based programming model for developing...

Thanks a lot for the reply!

I am using my own program, and I am not sure whether I am using RTOS yet, because I have never known about RTOS before, and I need to know more about it before I can be sure.

Also, I checked online and someone said that XDCtools will be automatically installed when installing CCS. I looked at the installation path of CCS and found a folder named "xdctools_3_61_02_27_core". Does this mean that I have installed XDCtools?

Jacktang

Yanluo Wuhen posted on 2021-9-22 11:55 Thank you very much for your reply! I use my own program. At present, I am not sure whether I use RTOS, because I didn’t know anything about RTOS before...

Yes