[Silicon Labs Development Kit Review] 2-Power on/Change LED Flashing Speed

dingzy_2002

[Silicon Labs Development Kit Review] 2-Power on/Change LED Flashing Speed [Copy link]

 

To use this kit, just download SimplicityStudio-5 and you can use it

When installing this software, the antivirus software may report an error. I just choose not to block the installation.

The installation speed is not slow, but to use it normally, you still need to log in or register on the official website, otherwise the related device DEMO program cannot be downloaded.

After opening the software, you need to connect the device:

And during the connection process, you need to download a lot of device libraries (SDK).

You need to be connected to the Internet all the time. During this process, you also need to update the firmware (after updating the firmware):

dingzy_2002

In the downloaded SDK, I selected Platform - Blink Bare-metal for LED blinking speed adjustment:

When the kit is powered on, the LED flashes at a rate of 1 Hz. In the bilink.C file, the delay time is 500 ms:

When TOOLGE_DELAY_MS is changed to 100 (5Hz):

freebsder

The big guy plays with the little gecko, looking forward to it!

dingzy_2002

When compiling, it is found that the SimplicityStudio-5 compiler is GUN ARM C

To be honest, the compilation speed is quite slow, much slower than MDK.

dingzy_2002

Use the official document to perform PWM modulation LED and breathing light test: