1935 views|4 replies

305

Posts

0

Resources
The OP
 

[New version of Zhongke Bluexun AB32VG1 RISC-V development board] - 0: Unboxing post - At this point it surpasses "UNO" [Copy link]

 This post was last edited by MianQi on 2021-8-6 12:57

Just received the board:

The pinout is obviously compatible with the Arduino UNO:

At first I thought the location of the screw hole was inconvenient but it is also compatible with UNO:

This also doesn't work:

This still doesn't work:

I was thinking whether I should change the caliber of screws like I did with UNO and make it like this:

Suddenly found this screw hole:

So it works, and we get the desired effect:

This post is from Domestic Chip Exchange

Latest reply

I have never used the genuine uno, the nuts glued on it?   Details Published on 2021-8-6 15:31
Personal signature

“Everyone wants the project to be good, fast, and cheap... pick two.”

- Unknown

 
 

1412

Posts

3

Resources
2
 
Looking forward to the subsequent works.
This post is from Domestic Chip Exchange
 
 
 

1942

Posts

2

Resources
3
 

I received it so quickly, looking forward to the follow-up review~

This post is from Domestic Chip Exchange
 
 
 

7462

Posts

2

Resources
4
 

I have never used the genuine uno, the nuts glued on it?

This post is from Domestic Chip Exchange

Comments

The nut is on the top and on the ground, and there is a copper column below. There are four screw holes on UNO. Among them, the screw hole on the left side of the USB interface and above the RESET button is too close to the pin, so a slightly larger nut is not level.  Details Published on 2021-8-6 16:54
Personal signature

默认摸鱼,再摸鱼。2022、9、28

 
 
 

305

Posts

0

Resources
5
 
freebsder posted on 2021-8-6 15:31 I have never used the genuine uno, what are the nuts stuck on it?

The nut is on the top and on the ground, and there is a copper column below. There are four screw holes on UNO. Among them, the screw hole on the left side of the USB interface and above the RESET button is too close to the pin, so a slightly larger nut is not level.

This post is from Domestic Chip Exchange
Personal signature

“Everyone wants the project to be good, fast, and cheap... pick two.”

- Unknown

 
 
 

Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list