What are the functions of the three buttons and three indicator lights?

lanhua

What are the functions of the three buttons and three indicator lights? [Copy link]

 

 

"STBOX" has three buttons and three indicator lights. What are their functions?

Is there any information? Where can I find it?

littleshrimp

You can take a look at this schematic first. One button is BOOT, one is "Power on", and the other is user-defined.

STEVAL-MKSBOX1V1 Schematic diagrams version 1 en.steval-mksbox1v1_schematic.pdf (477.6 KB, downloads: 15)

2021-1-13 13:34 上传

点击文件名下载附件

lanhua

Thanks!

What does a green light mean?

nmg

When you play with sensortile.box, you can refer to the experience shared by the previous netizens, which is summarized in the following post. The SensorTile.box part is summarized at the bottom of the post:

https://bbs.eeworld.com.cn/thread-1118352-1-1.html

nmg

There is also this summary of information, which can be read from the official website manual:

Get the relevant information required by SensorTile.box contestants (including official training, moderator evaluation)
https://bbs.eeworld.com.cn/thread-1116501-1-1.html

littleshrimp

lanhua posted on 2021-1-13 19:19 Thank you! What does the green light mean?

From the BOM table, you can see that green is LD4

According to the schematic diagram, the network controlling LD4 is CPU_LED2

Look for CPU_LED2 and see that it is only connected to PF2, which means it is an LED light controlled by the program.

If you are using the factory firmware, refer to dm00615085-how-to-use-the-wireless-multi-sensor-development-kit-with-customizabl.pdf (1.25 MB, downloads: 3)

2021-1-15 11:44 上传

点击文件名下载附件

for some instructions on the green LED.

en.steval-mksbox1v1_bom.pdf (68.78 KB, downloads: 1)

2021-1-15 11:35 上传

点击文件名下载附件

lanhua

Thanks! I downloaded it.

May I ask: Where did you find this document? ST.COM?

littleshrimp

lanhua posted on 2021-1-16 23:12 Thank you! I downloaded it. May I ask: where did you find this document? Is it ST.COM?

Yes, you can find it by searching the development board model on the official website.

lanhua

1.

What is the drawing length?

2.

Select 1S or 30S, and there is no change in the curve graph.

lanhua

always changes in seconds

littleshrimp

lanhua posted on 2021-1-19 23:30 Always changes in seconds

Comparing the settings of 30 seconds and 1 second, you will see obvious differences. When set to 30 seconds, one screen will display the data curve within 30 seconds. For example, if the sampling rate is 1 second, 30 data will be displayed. When set to 1 second, only 1 second of data will be displayed. If the sampling rate is 1 second, only one data will be displayed.

lanhua

knew:

The 1-30 seconds selection refers to the time when the horizontal axis fills the screen.

Thanks!