WinCE installation problem

asdmaill

WinCE installation problem [Copy link]

Yesterday I found a WinCE image for TI processor AM5728, wrote it to an SD card, and then inserted it into the board. After connecting the serial data cable, I found that the board could start the WinCE system normally, recognized the parallel LCD controller on the board, and obtained the IP address on the router through DHCP, but the connected LCD display did not light up. Since I don’t have much information at hand, I don’t know what to do next. Currently, the system can only run on the SD card. I want to write the system into the EMMC on the board. The WinCE version used is 2013