1948 views|0 replies

1140

Posts

0

Resources
The OP
 

msp430f1232 minimum system and debugging process [Copy link]

The minimum system is as follows:

The two capacitors on the 32768Hz crystal oscillator do not need to be soldered.

In order to see the msp430f1232 pin clearly, give a large picture

In addition to the TDO, TDI, TMS, TCK, RST pins connected to the corresponding lines of the msp430 JTAG port, the TEST pin must be connected to the TEST of the msp430, otherwise the following figure will appear:

With this pin, the chip model can be tested. If the model selected by the program is inconsistent with the board model, the following figure will appear:

This means that the TEST pin is used for this purpose. Generally speaking, if you see the above picture, it means that the JTAG connection is fine.

Minimum system welding diagram:

The diagram of the 14-pin JTAG port to 10-pin JTAG port mentioned in particular is as follows:

This post is from Microcontroller MCU
 

Guess Your Favourite
Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

Related articles more>>

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list