A novice asks about AD copper plating, thank you

poxiaochao

A novice asks about AD copper plating, thank you [Copy link]

After the copper is applied, there is an extra layer of PolyRegion. I looked at the previous board and found that there is no such layer. How can I cancel it? Thank you

btty038

You just deleted it or opened an extra layer. Also, you searched in the PCB design module and found a lot of them. You can't find them by looking them up. Send them to the big guys and reply to them if you see them.

qwqwqw2088

They are all on the MidLayer2 layer. I don't know how to determine that the PolyRegion with one more layer is the copper area.

btty038

qwqwqw2088 posted on 2018-12-18 17:25 They are all on the MidLayer2 layer. I don’t know how to judge that the extra layer of PolyRegion is the copper plating area

Have you found that AD sometimes has problems and it can be fixed by restarting it?