First pictureThis is a passive buzzer driver circuit. It should only need one IO port to output PWM control. What is the function of the other IO circuit here? D3 is not connected in parallel with the
[attach ]656568[/attach]
Previously there was a Raspberry Pi:
But... there is no HDMI cable with a small head...
This time, I got the wires, the box, and even the antenna. Maybe I can have some fun wi
SPI module introduction
Refer to 28. Serial Peripheral Interface (SPI) in Renesas RA2L1 Group User's Manual: Hardwarefeature2 channels
Supports full-duplex and send-only modes, 3-wire and 4-wire syste
[i=s]This post was last edited by qinyunti on 2022-11-12 10:27[/i]Prepare
The prerequisite is that MDK and JLINK have been installed.
MDK version V5.37
JLINK version V7.82 (V7.5 or above)Development b