Pulser circuit to interrupt the light beam
Source: InternetPublisher:风向双子座 Keywords: Pulse Generator Updated: 2024/09/26
As shown in the figure below, the circuit outputs a pulse when an object on the conveyor belt blocks the light. The light source keeps the phototransistor on. This will produce a high logic level voltage on the Schmitt inverter and a low logic level compatible with TIL at pin 5 of the monostable circuit. When the object blocks the light, TIL81 turns off the Schmitt inverter to trigger the monostable circuit.
- Multifunctional LC Oscillation Circuit Demonstrator
- DC negative high voltage generator
- Basic connection circuit of HA-5320 in the same phase unity gain mode
- 12kHz signal generator
- Analog-to-digital converter application circuit design analysis
- Sawtooth wave oscillator composed of integrating circuit and comparator
- Variable duty cycle oscillator
- 20~20000Hz low distortion audio oscillation circuit
- TTL level oscillator
- 800Hz single transistor oscillation circuit
- Timing pulse generator circuit
- trigger pulse generator circuit
- Circuit diagram of separately excited switching stabilized power supply using single-junction transistor as pulse generator
- Tachometer, single pulse generator, power loss detector, peak detector circuit diagram
- Ring oscillator pulse generator circuit diagram
- single tone pulse generator
- Single junction transistor controllable pulse generator
- Low frequency pulse generator circuit diagram
- narrow pulse generator
- Pulse generator using two complementary transistors