FPGA controls packet loss on Gigabit Ethernet ports

全部都是泡馍

FPGA controls packet loss on Gigabit Ethernet ports [Copy link]

I use FPGA to control the Gigabit Ethernet port to send data to the PC. The PC has a code for receiving data written on the Linux system on the virtual machine. When the frequency of sending data packets by my FPGA is low, the packet loss rate of the data packets received by the virtual machine is relatively low, and one or two data packets will be lost in tens of thousands; when the frequency of sending data packets by my FPGA is high, the packet loss rate of the data packets received by the PC is very high; this problem should be caused by the PC.

le062

First use the computer to measure the performance of the gigabit network port of this virtual machine.

全部都是泡馍

le062 posted on 2018-5-23 16:30 First use a computer to test the performance of the gigabit network port of this virtual machine

Thank you, how should this be tested, I don’t know much about networking.

le062

All are Pao Mo published on 2018-5-23 16:45 Thank you, how should I test this? I don't know much about the network.

Connect two computers together and use the existing LAN transmission software to test, or write your own code to test

全部都是泡馍

le062 posted on 2018-5-23 16:46 Connect two computers together and use the existing LAN transmission software to test, or write your own code to test

OK, thank you, I will try it