With the new version of AD smart board frame rules, you no longer need to draw lines on the keep out layer.

linchichang

With the new version of AD smart board frame rules, you no longer need to draw lines on the keep out layer. [Copy link]

In the past, when drawing boards, many people were used to drawing the board shape on the keep out layer to prevent the traces or copper from extending outside the board. Now, the board shape can be defined directly on the mechanical layer. Then, a rule is used to directly prohibit the traces on the PCB from being too close to the board edge. The specific method is in the attached document

qwqwqw2088

The document of the original poster said that "the higher version of Altium Designer has rules for directly using the PCB shape to define the board edge spacing." Which version has this function?

star_66666

That's good.

linchichang

qwqwqw2088 posted on 2018-5-23 08:26 The document of the original poster said that "the higher version of Altium Designer has already used the PCB shape to define the board edge spacing rules directly." Which version is the higher version from...

At least AD17

littlejia

Study and learn, https://blog.csdn.net/qq_44696271/article/details/102457864 also talks about this problem, it seems quite troublesome, this document is to set rules to achieve the function, better! It should be the standard use

littlejia

This is a good, very standard border drawing tutorial. This is how it should be done regardless of whether it is a high version or a low version.

littlejia

There is no such rule in ad09

历史的天空

Learned