top4412 development board-Android4.4-Set static IP
[Copy link]
This document mainly introduces the Android 4.4 system of the iTOP-4412 development board.
Settings to achieve fixed IP, Gateway, DNS and other functions. Applicable to the elite and all-round versions of Android 4.4.
Android 4.4 system has built-in Ethernet function, which uses DHCP to obtain dynamic
IP. Android4.4 also has a Static IP function in its settings.
As shown in the figure below, go to "Settings" -> "Wireless & networks" -> "More" -> "Ethernet".
(, downloads: 0)
Go to “Ethernet” -> “Static IP Settings” as shown in the figure above, as shown in the figure below.
Check "Use Static IP" (after all other parameters are configured and saved, this option can take effect)
IP--IP that the user wants to configure
Gateway sets the router's gateway. The author's router gateway is 192.168.2.1
Netmask is usually 255.255.255.0, and users set it according to the configuration of the router.
DNS1 and DNS2. It should be noted that if the router has no additional settings, both DNS1 and DNS2 are set to
The setting can be the same as the gateway, here it is 192.168.2.1.
It should be noted that after all configurations are completed, you can "save" to save. You must fill in all the configurations and save, otherwise it will not work.
The static IP is set successfully. The following figure is a screenshot after the author set it. If the save fails, it is probably because a parameter is not filled in.
(, downloads: 0)
Of course, in the upper level "Ethernet" of the above interface, you need to select "Use Ethernet", as shown in the figure below.
(, downloads: 0)
| 
提升卡
变色卡
千斤顶
京公网安备 11010802033920号
